Technical Discussion Topics related to Technical Issues

Front Axle Collar Dimension CBR 1000 RR

Thread Tools
 
Search this Thread
 
Old 11-13-2012 | 03:38 PM
  #1  
Mike Heffernan's Avatar
Thread Starter
Junior Member
Squid
Squid
 
Joined: Nov 2009
Posts: 10
From: Englewood Cliffs, NJ
Mike Heffernan is on a distinguished road
Front Axle Collar Dimension CBR 1000 RR

Do any of you front front end/wheel swap gurus know what is the width of the front wheel distance tube (or collar) on the CBR 1000 RR? I know it's 25mm I.D., what I'm asking for is the distance it maintains between the inside faces of the bearings. Thanks in advance for any help
Old 11-14-2012 | 05:23 AM
  #2  
98VTRrider's Avatar
Senior Member
SuperSport
 
Joined: Jun 2010
Posts: 636
From: Baltimore, Maryland
98VTRrider is on a distinguished road
I just pulled my CBR1000RR front end off. If I get time I can find those measurements for you. If I don't reply by a few days just send me a PM to remind me.

For "distance it maintains between the inside faces of the bearing", you mean as if the bearings were removed, the distance from the inside bearing land to the other side bearing land.

So if I measure from outside of each bearings would that help? could you subtract the thickness of both OEM bearings to get the measurement you want? I don't want to pull my bearings to get the measurement, if that's the measurement you need.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
maniac2313
Classifieds
15
07-05-2012 06:44 AM
salmanilla2000
Classifieds
3
03-29-2011 10:25 AM
bigbob65
Technical Discussion
2
05-25-2007 12:49 PM
ali_squidz
Technical Discussion
7
04-09-2007 06:46 PM
meangreen79
Technical Discussion
2
02-13-2007 06:53 PM




All times are GMT -7. The time now is 07:53 AM.