Carb Sync Vacuum Nipple
#1
Carb Sync Vacuum Nipple
Was looking at doing my first carb sync this weekend on the bike. I'm just using the 2 diy bottle set up with some rubber hose. The only thing I missed is the vacuum nipple that goes on the front cylinder. Found this part in another thread: 16214-MB0-000. however like I said I'm looking to do the sync this weekend. Anyone know either another way of hooking up the hose to the vacuum port or any sort of generic nipple that I'd be able to pick up at a store to get this done?
Thanks a bunch
Thanks a bunch
#2
Was looking at doing my first carb sync this weekend on the bike. I'm just using the 2 diy bottle set up with some rubber hose. The only thing I missed is the vacuum nipple that goes on the front cylinder. Found this part in another thread: 16214-MB0-000. however like I said I'm looking to do the sync this weekend. Anyone know either another way of hooking up the hose to the vacuum port or any sort of generic nipple that I'd be able to pick up at a store to get this done?
Thanks a bunch
Thanks a bunch
Its a simple M5x .8 straight thread so, you could drill a hole thought a M5x.80 thread screw run a nut and washer part way up, use some Teflon tape to seal it temporally for sycn
But I tell ya, getting the blanking plug out and the vacuum joint in is a pain in the *** unless you strip off body, tank and carbs....I would not do it twice...
for the price of shipping and a cup O Joe I'll send you one USPS, but doubt it will be there by this weekend.
#4
You can get um on amazon
With prime shipping I could have those tomorrow if I ordered now...
NOTE: those are not for permanent install, you will end up with a vac leak if you do.
You need a nipple with a shoulder and a copper or aluminum sealing washer
With prime shipping I could have those tomorrow if I ordered now...
NOTE: those are not for permanent install, you will end up with a vac leak if you do.
You need a nipple with a shoulder and a copper or aluminum sealing washer
#6
Its a simple M5x .8 straight thread so, you could drill a hole thought a M5x.80 thread screw run a nut and washer part way up, use some Teflon tape to seal it temporally for sycn
But I tell ya, getting the blanking plug out and the vacuum joint in is a pain in the *** unless you strip off body, tank and carbs....I would not do it twice...
for the price of shipping and a cup O Joe I'll send you one USPS, but doubt it will be there by this weekend.
#7
Ahh Ha, Amazon wins again.... https://www.amazon.com/Motion-Carb-V.../dp/B0012TTA5E
There is your permanent install vac adapter but shows even with prime shipping not until monday
There is your permanent install vac adapter but shows even with prime shipping not until monday
Thread
Thread Starter
Forum
Replies
Last Post
98VTRrider
Technical Discussion
5
12-20-2011 12:33 PM