Paging Shayne - Powerbronze Windscreen Mod
07-05-2006 | 07:26 PM
#1
Thread Starter
Administrator
World Champion
Joined: Dec 2004
Posts: 105,287
From: Fulton, MO
Paging Shayne - Powerbronze Windscreen Mod
Shayne,
I have the Powerbronze screen as well. Read in another post that you countersunk the rubber inserts somehow. What tool did you use?
TIA,
I have the Powerbronze screen as well. Read in another post that you countersunk the rubber inserts somehow. What tool did you use?
TIA,
07-08-2006 | 05:24 AM
#3
Senior Member
SuperSport
Joined: Dec 2005
Posts: 963
From: Sunshine Coast, Australia
Hi Greg, sorry for not replying sooner, but I haven't got on here recently as much as I used to.
I used a die grinder, what you guys call a dremel I think. I just used it enough to sit the rubber grommet level, which then allows the fairing to sit flat with the screen. The few aftermarket screens that I have seen have this problem
It is a bit tricky, as you need to keep and small it neat so you can't see it.
I used a die grinder, what you guys call a dremel I think. I just used it enough to sit the rubber grommet level, which then allows the fairing to sit flat with the screen. The few aftermarket screens that I have seen have this problem
It is a bit tricky, as you need to keep and small it neat so you can't see it.
Thread
Thread Starter
Forum
Replies
Last Post
little squirt
General Discussion
21
05-09-2009 11:24 PM
