WTB: Stock Bodywork
#1
WTB: Stock Bodywork
Preferably in decent shape, with few or no cracks. Color/cosmetics are unimportant, they are going to have Line-X applied to them (uhhh... don't ask).
I need both halves, the center section of the front fairing, and a tail section.
Thanks!
Mike
I need both halves, the center section of the front fairing, and a tail section.
Thanks!
Mike
#2
fairing pieces
I have the fairing . post wreck:
1.the right side is pretty brutalized.
2.The left side is in better shape. It has one .crack at the top rear mounting point.
3.the center has a small piece broken out below the headlight and a crack on the upper right, starting at the connector hole.
I'd let it go real cheap. If you are ambitious, let me know and I'll send pictures.
1.the right side is pretty brutalized.
2.The left side is in better shape. It has one .crack at the top rear mounting point.
3.the center has a small piece broken out below the headlight and a crack on the upper right, starting at the connector hole.
I'd let it go real cheap. If you are ambitious, let me know and I'll send pictures.
#3
I'm not sure on the right, depends on the structural damage. Sounds as if the others may just fit the bill, though.
Please, post or pm a link to pics (or I can PM you my email address if you want...)
Thanks,
Mike
Please, post or pm a link to pics (or I can PM you my email address if you want...)
Thanks,
Mike
#4
I have a left side with just scratches on it. It was from a tip over in some soft gravel, the kick stand just sunk in.
Dennis
Dennis
#6
PMs sent to KC-10ENG and Tom Blum.
Snowman, I can't wait to see it either. When it gets close, I'll share...
Snowman, I can't wait to see it either. When it gets close, I'll share...
#7
Tail Section...
Still looking for a tail section. Must be structurally sound, cosmetics unimportant.
Thread
Thread Starter
Forum
Replies
Last Post