Parting out 98
#1
Parting out 98
I have a lot of parts from a 1998.
If anyone needs any wiring, sensors, etc...I still have most of it. Just ask.
Short list includes:
-Rear Caliper with pads, rotor, master, and s/s line-$40 shipped
-Radiator Fan-$30 shipped
-Rear OEM signals-$25 shipped
-Unmolested Airbox w/ OEM velocity stacks-$35 shipped
-Fuel Tank with some dents and chips w/ petcock-$110 shipped
-L/R clip ons (right has very slight bend. Both have a little surface rust/some scratches)-$45 shipped
-L/R clip ons (perfect condition. These were off my bike, not the parts bike)-$80 shipped
-Stock Carburetor-slides are sticking a bit (No TPS)-$50 shipped
-4x stock cct't (2 with 9k, 2 with 20k)-$25 shipped
-ECU-$80 shipped
-Converter Unit-$60 shipped
-Front or Rear valve Covers-$50 each shipped
-Left controls (signals, horn, high beam)-$27 shipped
-Right Controls (starter, engine cut off)-$27 shipped
-Rear Wheel w/rotor, cush, and sprocket (some scratches..not too bad)-$80 shipped
-Tinted Windscreen (same shape as stock screen)-$27 shipped
-Stock windscreen-$27 shipped
-Speedometer w/just over 19K all tabs there, but left one is missing some of the black plastic case. A couple of dents on the top, small crack on the back, but overall not too bad.-$42 shipped-SOLD
-Left Radiator-$60 shipped-SOLD
-Yoshimura RS-3 slip on exhaust (stainless) w/ mounting brackets. Pretty rough shape (scratches, dents, etc). Recently repacked and new baffles installed. Would be great for track, or put new sleeves on-$75 plus shipping-SOLD
-Right Engine Cover (clutch) some small scratches-$75 Shipped-SOLD
-Stock Header-$60 Shipped-SOLD
-Sidestand switch-$15 shipped-SOLD
-Shifter with linkage and factory peg-$65 shipped-SOLD
-Right rearset and factory peg-$55 shipped-SOLD
-Passenger brackets with pegs-$65 shipped-SOLD
-Right Radiator-$60 shipped-SOLD
-Front OEM signals-$30 shipped-SOLD
-Sargent Seat-$275/split actual shipping (see pics below)-SOLD
-Fairing Stay-$65 shipped-SOLD
-Left Engine Cover (stator)-$80 Shipped-SOLD
-Main wiring harness-$75 Shipped-SOLD
-Fork Sliders-$65 shipped-SOLD
-Stock front calipers w/EBC HH pads (less than 500 miles), Goodridge stainless lines, master cylinder and brake lever (bled and ready to bolt on). Perfect condition (the pads alone would cost $70)-$80 shipped-SOLD
-Front Calipers with pads and s/s lines-$40 shipped-SOLD
-Complete choke cable-$22 shipped-SOLD
-Speed sensor-$22 shipped-SOLD
-Fairings (flat black. tabs intact)-$70 each plus shipping-SOLD
-Stator-$75 shipped-SOLD
*If you want pics of anything, just PM your email address and I will send them.*
I will accept money order, or PayPal.
If you need anything else that's not on the list, just let me know and I will give you a price.
Thanks,
Mike
If anyone needs any wiring, sensors, etc...I still have most of it. Just ask.
Short list includes:
-Rear Caliper with pads, rotor, master, and s/s line-$40 shipped
-Radiator Fan-$30 shipped
-Rear OEM signals-$25 shipped
-Unmolested Airbox w/ OEM velocity stacks-$35 shipped
-Fuel Tank with some dents and chips w/ petcock-$110 shipped
-L/R clip ons (right has very slight bend. Both have a little surface rust/some scratches)-$45 shipped
-L/R clip ons (perfect condition. These were off my bike, not the parts bike)-$80 shipped
-Stock Carburetor-slides are sticking a bit (No TPS)-$50 shipped
-4x stock cct't (2 with 9k, 2 with 20k)-$25 shipped
-ECU-$80 shipped
-Converter Unit-$60 shipped
-Front or Rear valve Covers-$50 each shipped
-Left controls (signals, horn, high beam)-$27 shipped
-Right Controls (starter, engine cut off)-$27 shipped
-Rear Wheel w/rotor, cush, and sprocket (some scratches..not too bad)-$80 shipped
-Tinted Windscreen (same shape as stock screen)-$27 shipped
-Stock windscreen-$27 shipped
-Speedometer w/just over 19K all tabs there, but left one is missing some of the black plastic case. A couple of dents on the top, small crack on the back, but overall not too bad.-$42 shipped-SOLD
-Left Radiator-$60 shipped-SOLD
-Yoshimura RS-3 slip on exhaust (stainless) w/ mounting brackets. Pretty rough shape (scratches, dents, etc). Recently repacked and new baffles installed. Would be great for track, or put new sleeves on-$75 plus shipping-SOLD
-Right Engine Cover (clutch) some small scratches-$75 Shipped-SOLD
-Stock Header-$60 Shipped-SOLD
-Sidestand switch-$15 shipped-SOLD
-Shifter with linkage and factory peg-$65 shipped-SOLD
-Right rearset and factory peg-$55 shipped-SOLD
-Passenger brackets with pegs-$65 shipped-SOLD
-Right Radiator-$60 shipped-SOLD
-Front OEM signals-$30 shipped-SOLD
-Sargent Seat-$275/split actual shipping (see pics below)-SOLD
-Fairing Stay-$65 shipped-SOLD
-Left Engine Cover (stator)-$80 Shipped-SOLD
-Main wiring harness-$75 Shipped-SOLD
-Fork Sliders-$65 shipped-SOLD
-Stock front calipers w/EBC HH pads (less than 500 miles), Goodridge stainless lines, master cylinder and brake lever (bled and ready to bolt on). Perfect condition (the pads alone would cost $70)-$80 shipped-SOLD
-Front Calipers with pads and s/s lines-$40 shipped-SOLD
-Complete choke cable-$22 shipped-SOLD
-Speed sensor-$22 shipped-SOLD
-Fairings (flat black. tabs intact)-$70 each plus shipping-SOLD
-Stator-$75 shipped-SOLD
*If you want pics of anything, just PM your email address and I will send them.*
I will accept money order, or PayPal.
If you need anything else that's not on the list, just let me know and I will give you a price.
Thanks,
Mike
Last edited by superh1998; 07-26-2011 at 06:17 PM.
#4
Sargent Seat-SOLD
****SOLD****
I am also selling my Sargent seat.
It is black with red piping and a red passenger section.
There is a little wear (if you want to call it that) on the back of the passenger section from the seat cowl, and 2 small indents from cowl (will probably come out over time).
It is in great shape (maybe 3000 miles with no rain or snow) and is VERY comfortable.
I weigh 150lbs, so I don't think the seat ever "molded" to the shape of my ***.
$275 and I will split actual shipping charges.
I am also selling my Sargent seat.
It is black with red piping and a red passenger section.
There is a little wear (if you want to call it that) on the back of the passenger section from the seat cowl, and 2 small indents from cowl (will probably come out over time).
It is in great shape (maybe 3000 miles with no rain or snow) and is VERY comfortable.
I weigh 150lbs, so I don't think the seat ever "molded" to the shape of my ***.
$275 and I will split actual shipping charges.
Last edited by superh1998; 04-02-2011 at 09:18 AM.
#13
hey buddy interested in a couple parts, i need a rear brake lever only, i need the headlight framing you no where the tacho is the tubing just there, i also need a engine casing the one with the oil glass, thanks heaps buddy maybe give us a buzz on 0413181300 names matt if thats easier
#16
hello, i want your rearset braket and rigth engine cover my email chsmk_981@hotmail.com
#18
All questions and PM's answered.
Updated parts still for sale on top.
If anyone needs electrical stuff (wiring, ECU, sensors) I still have most of it.
Updated parts still for sale on top.
If anyone needs electrical stuff (wiring, ECU, sensors) I still have most of it.
Last edited by superh1998; 04-05-2011 at 10:11 PM.
#19
Hey Mike, this is Javier. Please email me regarding some parts. javio1@sbglobal.net. Thanks! To all the other board members, buy his parts, he's a great guy!
Last edited by javio1; 04-09-2011 at 03:57 PM.
#21
D'oh! Screwed up my own email... javio1@sbcglobal.net
#28
I may be interested in the stock header. Jayduhbs@gmail.com